Hash oil, also known as cannabis extract, has become increasingly popular among marijuana users looking for a more potent and intense high. While traditional methods of making hash oil involve complicated and dangerous processes, making hash oil with water can be done safely and easily in the comfort of your own home. In this guide, we’ll walk you through the steps of how to make hash oil with water, from choosing the right materials to preparing and storing the finished product. With these simple instructions, you’ll be able to make your own hash oil with water in no time.
What ingredients are needed to make hash oil with water?
To make hash oil with water, you will need a solvent such as isopropyl alcohol, a non-polar solvent such as petroleum ether, and a container to mix the ingredients in. You will also need a heat source, such as a double boiler, to heat the mixture until the desired consistency is achieved. Lastly, you will need a filter to strain the mixture of water and hash oil.
What type of equipment is required to make hash oil with water?
To make hash oil with water, you will need a pyrex or glass baking dish, a double boiler, a wooden spoon, a strainer, a cheesecloth, and a vacuum pump. You will also need a high-proof alcohol, such as grain alcohol or everclear, and a heat source, such as a stove or hot plate. Finally, you will need the cannabis flowers or trim that you will be using to make the hash oil.
How long does it take to make hash oil with water?
Making hash oil with water is a relatively simple process that can take anywhere from 1-2 hours. The process involves dissolving the cannabis in a solution of water and ethanol, agitating the mixture for several minutes, and then filtering out the plant material. Depending on how much plant material is used and the desired potency of the oil, the process can take longer.
How is the hash oil extracted from the cannabis plant?
Hash oil is extracted from the cannabis plant using a process called solvent extraction. This process involves mixing the plant material with a solvent, such as water, and then carefully separating the liquid from the plant material. The solvent is then evaporated, leaving behind a concentrated oil which can be further refined to create a variety of products, such as hash oil.
Is it safe to consume hash oil made with water?
Yes, hash oil made with water is safe to consume. The process of making the oil removes the water and any impurities, leaving only the concentrated cannabis extract. Many people prefer to use water when making hash oil because it is a gentler process and results in a high-quality product.
Forums New posts Search forums. Whats new New posts New profile posts Latest activity. Members Current visitors New profile posts Search profile posts. Log in Register. Search titles only. Search Advanced search. New posts. Search forums. Log in. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. Does anyone know how to make hash oil with water? Thread starter jungsheezy Start date Jan 3, Hello, do any of you know how to make hash oil using water? If so please tell. I would not want to smoke or injest alcohol or coconut oil. To the best of my knowledge, you will not be able to get an oil with water. You can get bubble hash with water and ice, but not hash oil. THC is insoluble in water so it would not work as a solvent. Unless someone has come up with a way to make THC bleed into water, I dont believe it to be possible, not hash oil anyway. The most organic way to make a good hash would be the bubble bags or before bubble bags, there was ice hash or even the rolling box with the screens in it to catch the trichs, Good luck! Do you know of a way to make bubble hash without bubble bags? I would rather have that than oil. But I thought the only way is with micron bags or with tons of buckets. Yes, but it is much harder to do and I have not had real good luck with it, although it did work and made a very high grade of marijuana if not totally clean hash. I have always ended up with some plant material in the hash where the bags make it cleaner with little or no plant material in the hash. I am sure there is a write up on RIU somewhere on it. It is called ice hash. Basically, what you do is freeze your plant material over night. Cycle it in short bursts. Once the plant material has had a few surges, the plant material floats on top and the hash trichs fall to the bottom. Let it settle in the fridge for an hour or so, remove the plant material floating on top, siphon off the water and green material, then on the bottom, you have your hash. Keep doing this until you no longer get hash on the bottom. Do not surge it to much on each process to avoid as much plant material as possible. I am sure there is a write up on here somewhere. Do a search for ice hash. I may have forgotten something, but before I had Bubble bags, this is one way I made hash. You can also buy silk screen material for cheap and make your own bags. Go by the micron sizes of the bubble mans bags and they will work. You can also buy filter bags for aquarium ponds but I have never tried either of these two methods but have read about others using them. Good Luck! Thanks for the reply, but thats blender hash. Yellow colored, bubble hash is dark and bubbles when you smoke it. But thanks for the reply. Ok, then you have the hash made from screens in your rolling box, not exactly bubble either, but not bad. I think you want me to tell you something that cant be done. You want me to tell you that you can get hash oil by boiling it in water on the stove and then hash oil will float on top, it wont work. I did my best to answer your question. I am not going to tell you something will work when it wont. Like I said in all my messages, Good Luck, and I really mean that. Really, if you want true bubble hash, bubble bags are the only way to go. You have to use a bubble hash producing strain to get true bubble too. Not just any strain will bubble when you light it which is what bubble is. Good Luck, Flabs. YES M Hash oil is an extract of the chemicals which break down in solvents at certain temperatures mostly canabanoids , and then boiled down to a rather pure oil. Oily hash is just hash oil mixed back in with small amounts of carbon left over after extracting oil. If you have the right equipment, then you could attempt to distill THC from the plant directly, or from a tincture. No promises, this all comes from theoretical calculations, but I believe that it could work. You must log in or register to reply here.
Hash oil , also known as honey oil or cannabis oil , is an oleoresin obtained by the extraction of cannabis or hashish. It is a cannabis concentrate containing many of its resins and terpenes in particular, tetrahydrocannabinol THC , cannabidiol CBD , and other cannabinoids. There are various extraction methods, most involving a solvent , such as butane or ethanol. Hash oil is usually consumed by smoking , vaporizing or eating. Hash oil may be sold in cartridges used with pen vaporizers. Preparations of hash oil may be solid or colloidal depending on both production method and temperature and are usually identified by their appearance or characteristics. Color most commonly ranges from transparent golden or light brown, to tan or black. It is generally thought to be indistinct from traditional hashish , according to the UN Single Convention on Narcotic Drugs Schedule I and IV , as it is the separated resin, whether crude or purified, obtained from the cannabis plant.
